sold out !
Oscillatoscope1d video synthe black with
Manual Oscillatoscope1d ::ABOUT It can convert CV and optional audio signals into video and audio, the connector is stereo and works as a multiple to you can get the same signal you put in out again. It works by changing the frequency of oscillators that are synced to a composite video sync generator. The signal that is generated is output as audio on a mono mini jack connector, and as video on the RCA jack connector. ::CONNECTION inputs: - power jack: 9v DC + in the center - 3.5mm mono jack CV A+B: 0 to 5v - 3.5mm stereo jack starve: 0 to 5v (x to works as multiple feed tru, only the tip is used) outputs: - RCA: composite video - 3.5mm mono jack audio: audio output ::CONTROLS pots: - right top: starve (attenuation for CV) - left bottom: pitch A (range for CV) - right bottom: pitch B (range for CV) buttons: gray 6mm: mid pitch momentary. gray 12mm left: (off) sync horizontal, (on) sync vatical, (blink) no sync gray 12mm right: (off) high frequency, (on) low frequency white 6mm: mid pitch momentary. white 12mm left: (off) sync horizontal, (on) sync vatical, (blink) no sync white 12mm right: (off) high frequency, (on) low frequency black right side: interlaced or progressive. ::STANDARTS PAL seems to work on all devices i have tested it on. NTSC works on everything i have tested it on, but in the standard mode it did not work on my video projector, so i added a extra mode that makes it work on my video projector. the next time you power up it will start up in the mode that was last selected - PAL hold left 12mm gray button during power up - NTSC hold right 12mm gray button during power up - NTSC (video projector hack) hold left 12mm white button during power up
inc power sub and batery clip only EU or US